虚拟环境中视景的表示与生成

虚拟现实(Virtual Reality:VR)的飞速发展和PC机的广泛使用提出了基于PC的VR应用要求,视景的表示与生成是VR环境的基础与核心。文中介绍采用面向对象机制,在PC机上基于MFC和OpenGL实现的虚拟环境中视景表示与生成的方法。用该方法生成的视景具有良好的视觉效果。     

按Weibull分布计算滚动轴承的寿命和强度的可靠性

运用weibull分布推导出任意可靠性指标下滚动轴承的寿命和强度计算公式,给出了多列轴承和轴承系统的可靠性计算方法和公式,并按照工程的方法加以简化处理。     

可招回秘书问题

可招回秘书问题已由Yang,Petrucceol,Choe及Bal研究过。本文将这个问题纳入Snell框架,用相对最好者的位置函数Wn代替通常的相对名次,我们得到了各种招回概率下的最优停止规则,这些结果推广了文[7]—[9]。     

全息术在军用装备上的应用

本文介绍了全息术及全息光学元件，并分析了其在军用装备方面的应用实例以及特点。     

改革开放初期邓小平对军队政治工作指导方针的三次调整

改革开放初期,邓小平在领导军队现代化建设的进程中对军队政治工作指导方针作出了三次重大调整:恢复和发扬政治工作优良传统,破除"左"的思想干扰;军队要服从整个国家建设大局;军队政治工作以加强思想政治教育和制度建设应对各种严峻考验,确保政治上永远合格.这些重要的思想丰富和发展了毛泽东关于军队政治工作的理论,促进了国家和军队现代化建设又快又好的发展,对当下的军队政治工作仍发挥着重大作用.     

新疆兵团地区小学科学课教师队伍建设及授课现状的调查分析——以石河子市为例

义务教育阶段新课程体系全面进入试验阶段,新课程理念对小学科学教与学提出了更高的要求。为了更好的了解小学科学课的实施现状,本研究以新疆石河子市为例,采用问卷调查、访谈和课堂观察等方法对对石河子市小学科学教师的师资队伍现状进行了调查。调查结果显示：石河子市小学科学师资匮乏;小学科学教师的专业背景较差;青年教师居多;授课能力较低;科学教师参加教研培训活动的次数少,质量低;学校对该课程重视度不高。针对这一现状提出了相应的改革建议。     

Numerical investigation of the failure mechanism of cubic concrete specimens in SHPB tests

Cylindrical specimens are commonly used in Split Hopkinson pressure bar (SHPB) tests to study the uniaxial dynamic properties of concrete-like materials.In recent years,true tri-axial SHPB equipment has also been developed or is under development to investigate the material dynamic properties under tri-axial impact loads.For such tests,cubic specimens are needed.It is well understood that static material strength obtained from cylinder and cube specimens are different.Conversion factors are obtained and adopted in some guidelines to convert the material strength obtained from the two types of specimens.Previous uniaxial impact tests have also demonstrated that the failure mode and the strain rate effect of cubic specimens are very different from that of cylindrical ones.However,the mechanical background of these findings is unclear.As an extension of the previous laboratory study,this study performs numerical SHPB tests of cubic and cylindrical concrete specimens subjected to uniaxial impact load with the validated numerical model.The stress states of cubic specimens in relation to its failure mode under different strain rates is analyzed and compared with cylindrical specimens.The detailed analyses of the numerical simulation results show that the lateral inertial confinement of the cylindrical specimen is higher than that of the cubic specimen under the same strain rates.For cubic specimen,the corners are more severely damaged because of the lower lateral confinement and the occurrence of the tensile radial stress which is not observed in cylindrical specimens.These results explain why the dynamic material strengths obtained from the two types of specimens are different and are strain rate dependent.Based on the simulation results,an empirical formula of conversion factor as a function of strain rate is proposed,which supplements the traditional conversion factor for quasi-static material strength.It can be used for transforming the dynamic compressive strength from cylinders to cubes obtained from impact tests at different strain rates.     

破片侵彻多层间隔铝靶的试验及数值模拟研究

对破片侵彻多层间隔铝靶进行了试验和数值模拟研究,获得了破片在不同速度、不同侵彻角时破片的侵彻深度,在此基础上利用拟合的方式建立了计算公式,并将数值模拟结果和计算公式的计算结果进行了对比,结果表明两者吻合较好,所建立的计算公式可靠。     

Intel 86/330A与 VDU-140联机系统的实现

彩色显示系统在指挥、控制与通讯系统的建设中起着越来越重要的作用。本文介绍利用Intel 86/330A与VDU-140显示设备组成彩色显示系统,并着重描述在iRMX86操作系统上开展的工作。     

圆形减压环力学试验与壁厚对其耗能性能的影响

圆形减压环主要由钢管、铝管套筒和钢丝绳组成,由于其耗能特性强,因此在被动防护系统中得到了广泛应用。在边坡防护工程中,将钢丝绳一端固定,另一端连接在防护阻挡结构上,通过钢管与铝管套筒的摩擦和钢管的大变形来散耗冲击动能。首先分析了圆形减压环的工作原理,并对其力学性能进行了拟静力试验,再利用ANSYS/LS-DYNA软件,研究了圆形减压环在荷载作用下,不同钢管壁厚对其耗能性能的影响。结果表明：随着钢管壁厚的增加,圆形减压环的启动荷载也随之增大;在低速荷载作用下,钢管壁厚对圆形减压环的耗能性能影响较弱,但是随着加载速度的提高,钢管壁厚对其耗能性能的影响明显增加,耗能总量上升明显。